Jivelite vu meters3/9/2023 The DMP3 is calibrated to output +12 dBv (RMS, I think) when showing 0 on the VU meter (for a 1 kHz sine tone) - which is very hot! It means the peak level will be at +15 dBV, and then the overload margin is still up to 7 dB before maxing out at the specified +22 dBv (18 Volt!). wavelabs VU meters now also hoover around -10 dB. I'm close to clipping on the input converters in my sound card), but the reading of e.g. I now get peak levels just below 0 dBFS (i.e. I need to back down to the 12 o'clock position, at which the VU levels read around -10 dB. However, if I run that into my sound card, it overloads drastically. You should get similar results with your SM57 - which I think is what you say also? If I raise my voice, the VU meters peak, and the clip light comes on from time to time, but only momentarily. If I take my SM58, put the gain on hi (out position) and the knob at around 3 o'clock, I get around 0 dB on the VU meters at normal speech levels close-miced (like you normally use a SM58 on stage). I'm running it into my sound card, which is at nominal -10 dBv level, and on my setup, I can hardly approach any levels on the VU meters before it severely overloads the inputs. I have a DMP3 as well, and it is certainly a hot thing.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |